Tired pavers made even and tight again
Paver Restoration and Resealing in Deerwood, FL
Call (904) 817-0508 for a free restoration estimate on worn Deerwood pavers with peeling sealer or empty joints.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Can my worn Deerwood pavers be restored, and how soon can someone look?
Yes, a local contractor restores and reseals worn pavers in Deerwood, FL, and a reply is promised within 1 business day, often much sooner. The visit and the estimate are free, with no obligation. To book a look, call (904) 817-0508.
Restoration is for pavers that a wash alone will not fix: a coat gone cloudy or peeling, joints that have emptied and surfaces that have faded in patches. The goal is an even color, full joints and a fresh coat that sheds water again. Most of these jobs take a visit and a plan, not a guess. Snap a photo of the worst corner and ask for a free estimate.
Where around Deerwood is restoration work done?
A local contractor covers Deerwood and each place listed below, across Duval, St. Johns and Clay counties. Every place has its own page of local notes. For a street that is not named, call (904) 817-0508.
- Southside
- Southpoint
- Sandalwood
- San Jose
- San Pablo
- Beauclerc
- Bartram Park
- San Marco
- Arlington
- Mandarin
- Palm Valley
- Fort Caroline
- Ponte Vedra Beach
- Jacksonville Beach
- Brentwood
- Fruit Cove
- Arlington Hills
- Saint Johns
- Atlantic Beach
- Riverside
- Bellair-Meadowbrook Terrace
- Nocatee
- Cedar Hills
- Argyle Forest
- Royal Terrace
- Fleming Island
- Paxon
- Panama Park
- Palencia
- Lakeside
How do I know I need restoration and not just a wash?
Look at the joints and the shine. Safe Touch says empty joints or failed sealer turn a job into a two day restoration, not a same day spray. If the coat is flaking, cloudy or gone in tire tracks, a wash will not bring it back. For a quick opinion, call (904) 817-0508.
A plain cleaning suits pavers whose coat is mostly sound and whose joints are full, and the paver cleaning page covers that lighter job. Not sure which side you are on? Send a photo when you ask for a free estimate.
What happens to an old sealer that has failed?
It comes off first. Safe Touch says failed sealer is stripped and not coated over, because new product laid on a bad coat only hides the problem for a season. Family Handyman warns that extra layers can leave a film. To ask how the old coat would be removed, call (904) 817-0508.
Stripping is the step that moves a price above the normal range. Safe Touch says strip and reseal sits higher than a standard clean, sand and seal. It does not publish a figure, so ask for the strip work as its own line when you ask for a free estimate.
Why does restoring pavers usually take two days?
Water and sealer cannot share a surface. A local sealing company says pavers must be clean and dry before sealing, and that bedding sand can stay damp after rain. Unilock asks for 24 to 48 hours of clear skies before sealing and 24 hours dry after, up to 48 to cure. To plan around the forecast, call (904) 817-0508.
Day one is washing, stripping and sand. Day two is the coat, once the surface has dried. A storm can slide day two, so keep your calendar loose and ask the contractor for a start window when you ask for a free estimate.
Can restoration fix sunken or loose pavers?
Not by sealing. A coat locks in whatever sits under it, so a paver that rocks or has dropped is reset before anything else. Ask whether resetting is in the quote, because it is often priced apart. To raise that question, call (904) 817-0508.
Outercle says deep staining, flaking or heavy erosion may need restoration work before a surface can be sealed well. That means a driveway with oil rings, a sunken apron by the garage and a failing coat can turn into three small jobs. Describe each one when you ask for a free estimate.
Which joint sand and finish suit a restored driveway?
New sand goes into the joints once the pavers are dry, and the extra is swept clear. Sand comes in colors, so pick a shade that sits near your pavers. Then choose between matte, natural and wet look. To see samples, ask for a free estimate.
A wet look gives the deepest color and shows scuffs sooner, while matte stays closer to the paver's own tone. A driveway with daily tire turns often suits a lower sheen. For help picking a finish, call (904) 817-0508.
How long will a restored coat last in Deerwood?
Plan on two to five years. Safe Touch calls two to three years typical for this area and says full sun, pool chlorine and storms can pull it toward two. Unilock says three to five, and solvent-based sealer is said to reach four to five when kept up. To have a coat checked, call (904) 817-0508.
Resealing early will not help. Family Handyman says sealing more often adds no protection and can leave a film. Mark the date on your calendar and look again in two years. If water soaks in instead of beading, ask for a free estimate.
What does paver restoration cost near Deerwood?
No page for this area lists one price for restoration, so the table is built from published pieces. Safe Touch lists $1.75 to $3.25 per square foot to clean, sand and seal, and says strip and reseal sits higher. Sealer is only part of it: Unilock puts sealer at $80 to $150 a gallon, covering 80 to 150 square feet. For a figure on your drive, ask for a free estimate.
| Paved area | Typical example | Clean, sand and seal range | If the old coat must be stripped |
|---|---|---|---|
| 400 sq ft | Front walk and entry | $700 to $1,300 | Higher, set at the visit |
| 800 sq ft | Two car driveway | $1,400 to $2,600 | Higher, set at the visit |
| 1,200 sq ft | Long driveway with a turnaround | $2,100 to $3,900 | Higher, set at the visit |
| 2,000 sq ft | Driveway plus pool deck | $3,500 to $6,500 | Higher, set at the visit |
Math uses the $1.75 to $3.25 per square foot Safe Touch lists as of November 2026. No published page gives a strip and reseal number, so that column has no figure. Leveling pavers and joint repairs are usually extra.
What is special about restoring pavers on larger Deerwood lots?
Wikipedia says Deerwood has about 900 families on lots that average more than half an acre, along 16 miles of paved streets. Bigger lots usually mean longer driveways and wider pool decks. Square footage drives the price, so measure early. To get it done at the visit, call (904) 817-0508.
The same source says most homes here date from 1970 to 1999. A driveway laid in those years may have had two or three coats, and the old ones are the ones that fail. Tell the contractor what you know about the history when you ask for a free estimate.
Does a restored driveway need association approval in Deerwood?
Check before you book. Deerwood has a homeowners group, the Deerwood Improvement Association. A local sealing company says natural look sealer may count as maintenance, while color enhancing or gloss finishes more likely need approval. To plan around it, call (904) 817-0508.
That company also says gated communities can limit contractor hours and vehicle access. Ask your gate office about work hours and truck parking, then ask for a free estimate.
What is the paver restoration process, step by step?
The restoration process follows an order that does not change, and the dry time between steps is part of it. To get on the schedule, call (904) 817-0508.
1. Inspect and measure
The contractor measures, finds sunken pavers and checks how much of the old coat has failed.
2. Strip and wash
Failed sealer comes off, then the surface is washed with a low pressure fan nozzle kept out of the joints.
3. Dry and treat stains
Marks are treated, and the pavers dry fully, since damp bedding sand can hold water.
4. Re-sand the joints
Sand is swept in and topped off, then the extra is cleared away.
5. Seal and walk it
The coat goes on in one session, and the contractor tells you how long to stay off it.
What do restored pavers look like around Deerwood?
Frequently Asked Questions
How to seal a paver patio?
A contractor works in a set order: clean, re-sand the joints, then seal on a dry surface. Safe Touch lists that order. Unilock adds that the coat should go on in one session so the gloss stays even.
Is it good to seal pavers in Florida?
Usually yes, once the pavers are clean and dry. Summer storms wash sand from joints, a Safe Touch page notes, and a sealed surface holds that sand better. Sealing more often than needed adds no protection, says Family Handyman.
How to clean dirty pavers?
Gently, and never into the joints. Family Handyman suggests a white 40 degree nozzle and a test spot first, and Unilock says to avoid high pressure. A contractor chooses the cleaner for the stain.
Which paver sealer works well in Florida?
No single product fits every driveway. Unilock describes water-based sealer as easier to clean up and solvent-based as lasting four to five years when kept up. Ask which product is planned and why it suits your surface.
What does it mean to restore pavers?
It means fixing what a plain wash cannot: a failed coat, empty joints and stains. Safe Touch strips failed sealer first, then cleans, re-sands and seals, and it calls empty joints or a failed coat a two day job.
Can old sealer just be coated over?
Not when it has failed. Safe Touch says failed sealer is stripped first and not coated over. Family Handyman warns that extra layers can leave a film, and Unilock says layers laid over one spot can leave patchy gloss.
How long does restoration take in Deerwood?
Plan on two days. The pavers must dry between washing and sealing, and bedding sand can stay damp after rain, a local sealing company notes. Unilock asks for 24 to 48 hours of clear skies before sealing.
Will restoring my pavers fix sunken spots?
No. Sealing will not lift pavers that have sunk, so those sections are reset before any coat. Outercle also says deep staining, flaking or heavy erosion may need restoration work before sealing.
How much does paver restoration cost near Deerwood?
Safe Touch publishes $1.75 to $3.25 per square foot to clean, sand and seal, and says strip and reseal sits higher when the old coat has failed. A 1,200 square foot driveway starts near $2,100 to $3,900 before stripping.
Other paver services near Deerwood
Not sure this is the job you need? The pages below cover the other work a local contractor handles. To talk it over, call (904) 817-0508.
Ready for a free paver restoration estimate in Deerwood?
Send a photo or call, and a contractor replies within 1 business day, often much sooner.
Free, no obligation